Logo image
Modelling and computational optimization of different neural network architectures for prediction of depth of cut in abrasive water jet machining of Ti6Al4V
Journal article   Open access   Peer reviewed   PUBLISHED

Modelling and computational optimization of different neural network architectures for prediction of depth of cut in abrasive water jet machining of Ti6Al4V

Yakub Iqbal Mogul, Jaimon Dennis Quadros, Ganesan Subramanian, Prashanth Thalambeti, Ibtisam Mogul and Ma Mohin
Scientific reports, Vol.16, 30144
29/09/2026
PMID: 42380377

Abstract

Depth of cut Neural networks Ti6Al4V titanium alloy Abrasive water jet Optimization
The current work presents an optimized neural network for predicting depth of cut (DoC) in the abrasive water jet machining (AWJM) of Titanium Ti6Al4V Grade 5 material. Five process parameters were used for experimentation i.e., water pressure (W ), traverse speed (T ), nozzle to orifice diameter (N/O ), abrasive mass flow rate (A ), and abrasive orifice size (A ). Experiments were carried out using the Taguchi based L Orthogonal array, resulting in the development of a regression equation describing the process behaviour. The DoC was modelled using two neural network architectures: a single hidden layer network (NN ), where neurons were varied from 1 to 10, and a deep neural network (NN ), where both neurons and hidden layers were varied to determine the optimum network configuration. Four different activation functions, namely, Sigmoidal, Gaussian, Tanh, and Linear functions were employed to perform the optimization. The dataset for training and testing the neural network models was generated using the regression equation based on experimental data, rather than direct experimental measurements. The optimization of both the neural network architectures was evaluated using two performance metrics, i.e., root mean squared error (RMSE) and co-efficient of determination ([Formula: see text]). The results concluded that both the neural network (NN) models were able to accurately predict DoC, however, the NN was found to be better in terms of accuracy with a 12.5% reduction in testing RMSE and 4.2% improvement in testing ([Formula: see text]). Amongst the activation functions used, the Gaussian functions outperformed the other functions across both neural network architectures, as its symmetric response reflects the jet energy distribution peaking at the centre and decaying radially, thereby effectively capturing the non-linear penetration behavior. SEM analysis supported the computational results, showing micro-cutting with stable grooves for machined surfaces with higher DoC, whereas lower DoC experienced micro-ploughing and ridge formation. Contour plots further revealed that DoC in AWJM of Ti6Al4V is primarily governed by water pressure and traverse speed, thereby confirming the capability of the optimised NN architecture to capture the underlying physical mechanisms of AWJM.
pdf
Modelling and computational optimization of different neural network architectures for prediction of depth of cut in abrasive water jet machining of Ti6Al4V8.86 MBDownloadView
Published (Version of record) Open Access CC BY-NC-ND V4.0  — This license enables reusers to copy and distribute the material in any medium or format in unadapted form only, for noncommercial purposes only, and only if attribution is given to the creator.
url
Link to publisher versionView
Published (Version of record) Open Access Open CC BY-NC-ND V4.0  — This license enables reusers to copy and distribute the material in any medium or format in unadapted form only, for noncommercial purposes only, and only if attribution is given to the creator.

Metrics

1 Record Views

Details

Logo image

Usage Policy